*Caution!!* Changing this setting below “0” can cause unexpected freeze-ups!
Our default setting is “1”. Going into negative numbers is more “aggressive” but for many people it's dangerous. Many people need to bump up to positive numbers. See troubleshooting, if it's freezing up, you may want to INCREASE your FIN setting up to 2 or 3.
1. Press the right arrow so you are in "Fin" mode (the light over Fin will come on at the top)
2. Press the center check mark
3. The current setting will blink in the screen. 1 is default. -1 would be more aggressive but can cause ice-ups depending on your situation. If you are getting freeze-ups, you would RAISE the setting (to 1 or 2) using the arrow
4. Press the check mark again to set it into memory